For clean and healthy water, maintenance of a pool must be done regularly. Discover all the tricks to fight against bacteria and keep the pool water clean.
Why maintain the pool water?
The landscapes surrounding the pool are factors that affect the water balance of the basin. Sun, storm, temperature, dirt and hair swimmers, their dandruff, sweat, dander, suntan oils and beauty products are sources of imbalance.
These are soils that serve as food for bacteria and viruses, fungi, algae and fungi. These micro-organisms are so small that they pass through the filters used for cleaning. So they come in the basin and the water in your pool eventually become cloudy, green, brown or whitish.
We must begin by removing leaves, debris and insects floating in the pool. The filtration system must be used for cleaning, and skimmers. Moreover, it must be treated regularly with chlorine and anti algae. It will be the same for the treatment pH, since the proliferation of bacteria is dangerous for swimmers. If you want to details information about swimming pool remodeling you could visit pool remodeling phoenix.
Three steps to properly maintain the water in a swimming pool
1 Clean the pool
The scoop used to clean the dirt on the surface, such as dead insects, leaves and other debris. As to those deposited at the bottom such as sand and soil, it is necessary to have a pool vacuum to remove them. But before that, however, must pass the pool brush. We must also think to spend a sponge on the water line to remove fat deposition. Products for above ground pool are available in specialty stores.
2 Filter the water in the pool
The above-ground pools, regardless of the model, rigid or semi-rigid, are always sold with the filtration system and pump that goes with it. In case of defection of the latter, other models can make the water clear, and, while eliminating bacteria.
Filtration systems operate independently when connected, that is to say, water is pumped from the pool to be purified before being reinjected. The basket that holds dirt and filter should be changed regularly. To do this, follow the instructions carefully.
3 Treat the pool water
The rate of disinfectant and pH should be monitored weekly. Moreover, complete kits are available to rectify this rate. The standard is between 7.2 and 7.6.
When it is below, use the stripper pH + since there is a risk of eye irritation. And above this standard, it is preferable to use a pH corrector to prevent algae growth.
These markers exist in liquid form, granules, tablets and lozenges. However, do not put it directly into the pool, but in the pump.